DODGE 5.7L HEMI ENGINE
This Dodge 5.7l Hemi engine, known by the trademark Hemi, is a series of V8 engines built by Chrysler. With a hemispherical combustion chamber. Three different types of Hemi V8 engines have been built by Chrysler for automobiles:
- the first (known as the Chrysler FirePower engine) from 1951-1958,
- the second from 1964-1971, and
- the third beginning in 2003.
DODGE 5.7L HEMI COMBUSTION CHAMBER
With a hemispherical (i.e. bowl-shaped) combustion chamber it allows the valves of a two-valves-per-cylinder engine to face each other across the chamber, rather than opening side-by-side. This layout makes space in the combustion chamber roof for larger valves and straightens the airflow passages through the cylinder head. This creates what is known as a cross-flow head. Where the intake charge flows directly across the chamber to the exhaust valve located directly opposite it. Actually, a “cross-flow head” is only a term for an engine that has the intake manifold on one side, and the exhaust on the other. Therefore as opposed to both manifolds being located on the same side of the engine, or cylinder head. This cross-flow design allows the air to flow in one side and out the other, which adds efficiency and power.
DODGE 5.7L HEMI REVERSE FLOW ENGINE
A “reverse-flow” engine requires the gases to flow in, stop, and reverse direction. A hemispherical engine spreads the valves apart and places them at an angle to decrease resistance. But it’s only an improvement on a crossflow head. These features significantly improve the engine’s airflow capacity, which can result in relatively high power output from a given piston displacement. However the design can also significantly increase the flow of incompletely combusted air-fuel mixture straight out of the exhaust valve.
With a hemi combustion chamber, there is minimal quench and swirl to burn the fuel-air mix thoroughly and quickly. And the spark plug is frequently placed at or near the centroid of the chamber to facilitate complete combustion. Hemispherical combustion chambers, because of their lack of quench, are more sensitive to fuel octane rating. Therefore a given compression ratio will require a higher octane rating to avoid ping in a hemi engine than in a wedge engine. Engines with hemispherical combustion chambers often use dome-topped pistons to attain the desired compression ratio but this design only works best at high R.P.M.
DODGE 5.7L HEMI CYLINDER HEAD
This hemi head usually has intake and exhaust valve stems that point in different directions, requiring a large, wide cylinder head. Also complex rocker arm geometry in both cam-in-block and overhead cam engines. This adds to the overall width of the engine, limiting the vehicles in which it can be installed.
2005-2012 Dodge 5.7L HEMI
|05-08 Ram, Jeep, Durango, Commander SUV Charger,Aspen, C300, Vin 2, H(With MDS and EGR Only) With Multiple Displacement Engine Only|
|2009 300, Charger, Challenger, Commander, Grand Cherokee, Durango, Vin TENGINE ID: EZD, EZH, 2152AD MDS Solenoids (With MDS and VCT Only/No EGR)|
With Multiple Displacement and VCT Engine Only- Passive Intake
|09-12 Challenger, Vin T (Without MDS, with VCT)ENGINE ID: EZC Without MDS, With VCT, Passive Intake|
|2009 Ram, Aspen, Durango, Vin T (With MDS and VCT Only/No EGR)With Multiple Displacement and VCT Engine Only – Active Intake|
|10-12 Grand Cherokee, Challenger, 300, Charger, 2010 Commander, Vin T (With MDS and VCT Only/No EGR)ENGINE ID: EZD EZH, 2298AA MDS Solenoids With Multiple Displacement and VCT Engine Only- Passive Intake|
|10-12 Dodge Ram 1500, Vin T (With MDS and VCT Only/No EGR)With Multiple Displacement and VCT Engine Only – Active Intake|
|09-12 Dodge Ram 2500/3500, Vin T (Without MDS and VCT Only/No EGR)Without Multiple Displacement and VCT Engine Only – Active Intake|
2013-2017 Dodge 5.7L HEMI
|13-17 Challenger, Charger, 300, Grand Cherokee, Durango, Engine ID EZH, Vin TWith MDS and VCT Only – With Multiple Displacement and VCT Engine Only||L5713CR|
|13-17 Dodge Ram 2500/3500 , Engine ID EZC, Vin T (W/O MDS and VCT Only)Without Multiple Displacement and VCT Engine Only – Active Intake||L5713TCR|
|13-17 Dodge Ram 1500, Engine ID EZH, Vin T (With MDS and VCT Only/No EGR)With Multiple Displacement and VCT Engine Only – Active Intake||L5713TCRM|
|13-17 Dodge Challenger, Engine ID EZC, Vin T Without MDS – VCT Only/No EGR)Without Multiple Displacement – VCT Engine Only||L5713HPCR|
Roadmaster remanufactures engines to supply quality customer satisfaction.
Satisfaction and peace of mind is what you experience when buying from Roadmaster. You won’t find better customer service and the thoroughness we offer to make sure what you’re looking for is correct. We know that’s what you expect. Buy from Roadmaster and you won’t be disappointed.
Roadmaster has been remanufacturing engines for over 50 years.
Contact us at 800-447-9899 or email us with your questions and requests.
In addition take a look at our dependable remanufactured engine process.
Furthermore, feel free to leave a comment. Share us as well!
Subscribe to our blogs and keep up with Technical Bulletins, Car Care Tips, engines and transmissions: