2003-2006 Ford 6.0L VIN P diesel engines
The AERA Technical Committee offers the following information on a cylinder head gasket caution on 2003-2006 Ford 6.0L VIN P diesel engines. This cylinder head gasket caution should be referenced any time head gaskets or cylinder heads are being replaced.
The manufacturer for this engine uses two separate facilities, one in Indianapolis, Indiana and the other in Huntsville, Alabama. While both locations build engines with the same critical data, three cylinder head variations have been used. There are engine serial number change dates to help in determining which cylinder heads were used.
The cylinder head gasket and locating dowels also changed in the 2006 year to accommodate the increase in the dowel size from 18 mm to 20 mm. (Block serial numbers left bank rear just below deck surface) Using the wrong head gasket for the application will lead to engine damage if assembled that way. The revised dowel hole was made to accommodate the larger head bolts to be used in the new 6.4L diesel engine and communization for manufacturing purposes. The injector clamp design and associated cylinder head casting support area were also modified on the changeover date in early 2006.
If there is a difference of dowel hole size between the head and block, a special “stepped dowel” Part #6C3Z-6B041-B, is available to accommodate proper assembly. The cylinder head gasket and injector clamp versions are not interchangeable; they must be used with the corresponding cylinder head versions.
Contact us at 800-447-9899 or email us with all your questions and requests.
Follow us on our Facebook page.
In Conclusion take a look at our dependable remanufactured engines process on our home page.
Roadmaster has the best service with over 50 years in business experience and customer care.
Furthermore, feel free to leave a comment. Share us as well!
Subscribe to our blogs and keep up with Technical Bulletins, Car Care, engines and transmissions: